Electrical power UNITS FOR LIFT TABLE one
General Description
This power unit is designed solely for your compact lift table,Consisting of large stress gear pump, AC motor, multi-functional manifold, valves, tank, etc. This electrical power unit continues to be widely made use of within the market of logistic devices such as minifork lift, scissors lift and ariel doing work platforms. The lower-ing motion is controlled from the solenoid valve together with the pace managed by the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE 2
Common Description
This power unit is designed solely for your medium lift table, Consisting of extremely effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The decreasing movement is actived from the solenoid valve plus the pace managed by the adjustable needle valve. When the lift rises to a large positoin, however the electrical power supply is minimize, the reducing motion is controlled from the guide override function.
Electrical power UNITS FOR LIFT TABLE 3
Common Description
This energy unit is created exclusively for the large lift table, Consisting of highly effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement is actived through the solenoid valve and also the pace controlled by a pressure compensated movement manage valve.
Electrical power UNITS FOR LIFT TABLE four
Common Description
This power unit is made exclusively for your massive lift table, Consisting of remarkably effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived by the solenoid valve as well as pace managed by the adjustable needle valve. When the lift rises to a high positoin, but the energy supply is cut, the decreasing movement is controlled by the guide override perform.
Special Notes
1. This electrical power unit is of S3 duty cycle, which can only do the job intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
2. Clean each of the hydraulic parts concerned in advance of installation of the power unit.
3. Viscosity with the oil shoud be 15~46 cst,which should also be clean and free of charge of impurities.N46 hydraulic oil is proposed.
4. Oil changing is needed soon after the first a hundred operation hrs,afterwards after each and every 3000 hours.
5. The power unit shown is made to be mounted vertically.
Electrical power UNITS FOR LIFT TABLE
Tags: